Page 6 of 10
EPH-N00-06020
1-26-00
6
- ALL DOORS
Measure the wall-to-wall opening at the top
of the wall jambs [B] and cut the header [H] to fit
the exact opening. Using a 3/16" drill bit, drill the
interior face of the header on both ends as shown.
Strip two clear vinyl jamb seals [K] into the
door panel [L] splash guard and the pivot jamb
[M] and trim flush at the ends. Both vinyls should
be turned to trap water from the shower head.
Secure the vinyls with a small quantity of glue or
caulk at each end or by carefully crimping the
vinyl pocket. Set the door panel aside.
Press the pivot jamb and strike jamb [N] (with
magnetic strip) over the two 180° posts [G]. Refer
to Step #1 for the proper handing of the door.
NOTE: The magnetic strip on the strike jamb
must face the exterior and the clear vinyl jamb
seal on the pivot jamb must face inward.
7
- ALL DOORS
Press the header [H] over the wall jambs [B]
and the two 180° posts [G]. Plumb the posts,
moving them laterally as required to maintain
proper coverage on the fixed glass panels [F]. The
minimum horizontal dimension for the door
opening is the door panel width (see the graphic in
Step #8) plus 1/2", maximum is the door panel
width plus 1 3/4". Using the holes in the ends of
the header and curb as a guide, drill four 1/8" holes
into the wall jambs. Drill two 1/8" holes thru the
header and curb into each 180° post as shown,
then enlarge the four outer holes with a 3/16" drill
for clearance on the self-tapping screws. Secure
the header and curb to the wall jambs and 180°
posts with eight #8 x 1/4" truss head screws [J].
CAUTION: Slide the glass panels away from the
wall jamb before drilling to prevent breakage.
8
- 790 DOORS ONLY
