Page 4 of 10
EPH-N00-06020
1-26-00
1
- ALL DOORS
The Alumax 795
StikStall
Shower Enclosure
is completely reversible and may be installed
pivot-left or pivot-right (hinge-left or hinge-right).
The door may pivot from either center post. For
maximum waterproofing, the pivot (or hinge) jamb
should always be opposite the shower head. Using
the diagram, determine the correct position for
the door in your particular
StikStall
installation.
This instruction sheet depicts a pivot-right (hinge-
right) installation.
NOTE: Fixed glass panel size should be determined
by formulas shown on Alumax detail sheets.
CAUTION: For safety reasons, the door panel
must always open outward.
The Alumax StikStall framework has been designed to work with a variety
of different door types. To ensure correct installation, this 795 Instruction Sheet
is designed to be used by itself with a 790 Framed Pivot Door or with an instruction
supplement packed with a 390 Frameless Pivot Door, a 790i Intre-Hinge Door or
a 1090 Heavy Frameless Pivot Door.
Each step in this primary instruction sheet will indicate whether it applies to
all door types or if a supplement should be used. If your door panel kit does not
have an instruction supplement, then contact your dealer for the proper instructions.
790 door panel kits are covered in this instruction, therefore will not come with a
separate instruction supplement.
2
- ALL DOORS
Measure the opening at the bottom of the
shower stall and cut the curb [A] (with weep slots)
to fit the full width of the opening. If required, use
a file to round the lower corners of the curb to fit
the shower sill properly.
Using a 3/16" drill bit, drill the interior face of the
curb on both ends as shown.
Position the curb in the middle of the sill with the
weep slots to the interior and mark its position
with a pencil line along the interior and exterior
b a s e .
