OmniAccess 6000 LC-2G24F Installation Notes: Installation Guide
6
Part 031658-00
May 2005
Grasp the module handle firmly and draw the line card forward from its slot.
There may be moderate resistance as the module comes free from its
connections with the chassis backplane, but do not use excessive force. Once
disengaged from the backplane, the line card should easily slide out the rest of
the way.
Cover blank slots.
For safety considerations, as well as to promote proper airflow for cooling and
to prevent dust from entering the switch chassis, cover any unoccupied slot
with a blank cover plate.
Port and Cable Specifications
FE Port
The FE port provides a 10/100 Mbps Ethernet connection. The RJ-45 female
connector port pin-outs are shown below:
The port accepts a 4- or 8-conductor Category 5 UTP Ethernet cable with an
RJ-45 male connector. A straight-through cable is required for connection to a
network port. A crossover cable is required for connection to a management
workstation.
For cables that run through plenums or air-handling spaces as described in
NEC (2002) Article 300.22(C), the cable should be suitable under NEC Article
800.50 and marked accordingly for use in plenums and air-handling spaces
with regard to smoke propagation, such as CL2-P, CL3-P, MPP or CMP. Be sure
to install cables in accordance with all applicable local regulations and
practices.
5
10/100 Mbps Ethernet
RJ-45 Female
Pin-Out
*POE optional
**Serial optional
Serial TxD**
(POE positive*)
Serial TGND**
(POE positive*)
Serial RxD**
(POE negative*)
Serial RGND**
(POE negative*)
1
2
3
4
5
6
7
8
ETH Rx+
(POE
negative*)
ETH Rx–
(POE
negative*)
ETH Tx+
(POE
positive*)
ETH Tx–
(POE positive*)
Direction
Input
Output
