Alcatel OmniAccess 6000 OAW-LC-2G24F Installation Instructions
3
Access Point Status LEDs
Each LED represents the status of APs connected to a specific port on the
switch. During operation, the LEDs provide the following information:
The LED states listed above are listed in order of precedence (highest to
lowest). If more than one AP is connected to the port, the state with the
highest precedence is displayed.
2 GE ports
Each GE port has its own LNK/ACT LED, located to the right of the port.
During operation, these LEDs provide the following status information:
T
ABLE
3
Line Card AP Status LED
Status
Description
Red (solid)
An AP on this port has failed (highest precedence).
Red (flashing) An air monitor on this port has detected an unsecured AP.
The AP is attached to your network but is not listed in the
switch security policies. If security policies are enabled,
clients are not granted access to your network through the
unsecured AP.
Green
(flashing)
An air monitor on this port has detected interference. The
interfering device (AP or other radio source) has been
detected by your valid APs, but has no wired presence on
your network.
Amber (solid)
Load balancing is enabled on this port or an AP has reached
the maximum number of clients it is configured to support.
Green (solid)
All detected APs on this port are operating as expected.
Off
No AP is detected on the port (lowest precedence)
T
ABLE
4
GE LNK/ACT LED
Status
Description
Off
No Ethernet link on the port.
Green
An Ethernet link has been established on the port, but no
data is currently being transmitted or received.
Flashing
Green
The port is transmitting or receiving data. The flashing rate is
proportional to your network activity.
Amber
The Ethernet link on the port is encountering errors.
5
6
