7
Charging Warning
Do not charge alkaline batteries in this
scanner. Doing so may cause serious
damage to the product and void the
warranty. Before attempting to
recharge batteries, make sure you
have installed four rechargeable
nickel-cadmium batteries.
Flexible Antenna
Attach the flexible antenna to the
BNC connector.
Belt Clip
Do not tighten the screws too tight.
You can damage the case or clip.
Installing the Batteries
1. Open the cover.
2. Insert batteries according to the
polarity symbols inside the battery
compartment.
Warning:
Do not mix alkaline batteries with Ni-
Cd batteries. Be sure to install four
batteries of the same type.
3. Replace cover and press down until
it clicks into place.
AC Adapter/Charger
(not supplied)
Using an adapter/charger to power the
UBC105XLT
from a wall socket.
There are two external power jacks-
POWER Jack and CHARGE Jack.
The POWER Jack powers only the
scanner and it is not connected to the
batteries.
The CHARGE Jack supplies power to
scanner and batteries. Use this Jack
only when you have installed
rechargeable batteries.
Warning: Do not use the CHARGE
Jack if you have installed non-
rechargeable batteries.
