20
4.3.4 Displays in the menu
Pressing button [31] for about two seconds switches the driving screen (see chapter 4.3.2)
to the menu. Here you can make various settings (see diagram here) and view system
data.
You navigate through the menu and the associated submenus with buttons [30] and [32]
and you select a menu option with button [31].
Switch off: The e-pilot is switched off
Tour reset: The data for the tour travelled is set to “zero”
Back:
Back to the driving screen (without changes)
Driving mode
submenu
SPORT: Dynamic calibration of acceleration and turning performance
TOUR: Medium acceleration values
ECO: Gentle acceleration values
Traction assistance
submenu
This is the anti-slip regulation that reduces spinning of the drive wheel during start-up.
Easy display
submenu
The displays [54] and [55] described in chapter 4.3.2 are omitted. Instead, the residual
capacity of the battery pack is displayed.
Bluetooth
submenu
The MAC address and name of the e-pilot are displayed here.
You require both pieces of information to operate the e-pilot with a mobility app (avail-
able as an accessory).
Settings
submenu
Date:
First the year is set, followed by the month and then the day.
After you set the day, the menu is automatically displayed again.
Time:
First the hour is set, followed by the minute.
After you set the minute, the menu is automatically displayed again.
Language: Here you can select the language used to display the information on
the driving screen, menu and submenu.
Units:
Select kilometres or miles
Brightness: Here you can adjust the brightness of the display screen
to your preferred level
Back
You return to the menu.
Information
submenu
Technical information about the display (software), motor (hardware and software) and
battery pack (hardware and software) are displayed here. Your specialist dealer requires
this information to carry out repairs or update the software.
Switch off
Driving mode
Traction assistance
Tour reset
Easy display
Bluetooth
Settings
Information
Back
Take care when travelling on slopes!
Never exceed the preset maximum speed.
The e-pilot registers the speed you are travelling at and automatically switches off the electromotive support if the
maximum speed is exceeded.
This means that the wheel is then freewheeling and the throttle handle has no function!
In these situations, the speed has to be reduced until the e-pilot is once again under the maximum permissible
speed. The throttle handle [1] can only be used for driving again once this has happened.
If you decide to use the Mobility Plus Package for the e-pilot, make sure to observe the instructions in the operating
manual and the prerequisites for increasing the intended maximum speed. Failure to observe the instructions, partic-
ularly the safety and hazard information, shall result in exclusion of liability on the part of Alber GmbH.
Summary of Contents for e-pilot
Page 3: ......
Page 4: ...Abmessungen Akku Pack ...
