Albatron PX865PEL-800, Instruction Manual, Page: 33 / 53

PX865PEL-800
30
IDE Primary / Secondary /Master / Sla
Ultra DMA/100 functionality can be implemented if it is
ve UDMA
supported by the IDE hard drives in your
stem. As well, your operating environment requires a DMA driver (Windows 95 OSR2 or a third
arty IDE bus master driver). If your hard drive and your system software both support Ultra
MA/100, select “Auto” to enable BIOS support. Options: Auto (default)
、
Disabled
**OnChip Serial ATA Setting***
n-Chip Serial ATA
his item allows you to select the “On-chip Serial ATA” operating mode.
ote: You must use the “Combined Mode” if you have a Windows 98/Me operating system and you
ant to install SATA devices).
ptions: Disabled (default) Disable on-chip serial ATA
Auto BIOS will auto-detect the presence of SATA devices.
Combined Mode Allows SATA devices attached to this board to simulate a PATA
device by using one of the PATA channels. This mode is necessary if
you have a Windows 98/Me operating system and you want to use
TA devices. Windows 98/Me supports PATA devices but does not
pport SATA devices directly.
l ATA Port0 Mode” and
“Serial ATA Port1 Mode” fields).
ode allows you to use all of the PATA and SATA connectors
le. If you select this option, you must configure one of the
channels as the master SATA device (see “Serial ATA Port 0
erial ATA Port0/ 1 Mode
ports. The options are determined by the
ndary Slave
sy
p
D
*
O
T
(N
w
O
SA
su
When you use this mode, you must specify which PATA channels to
use with your SATA devices (see “Seria
Enhanced Mode This m
ab avail
SATA
Mode”).
SATA Only Use the SATA devices only
S
This field determines the operating mode of the SATA
“On-Chip Serial ATA” field.
On-Chip Serial ATA – Combined Mode:
When you set the “On-Chip Serial ATA” to “Combined Mode”, you must select one of the PATA
channels to use with the SATA devices. The PATA channel that you use must NOT be currently in
use by another disk device.
Options: Primary Master, Primary Slave, Secondary Master, Seco
On-Chip Serial ATA – Enhanced Mode:
When you set the “On-Chip Serial ATA” to “Enhanced Mode”, you must determine which of the
SATA devices will be the master SATA device. You configure this with the “Serial ATA Port 0
Mode” field only.
Options: SATA0 master, SATA1 master