PX845PEV/ GEV Series
40
Onboard LAN Device
This option allows you to control the onboard LAN Device.
Options: Enabled (default)
、
Disabled
Init Display First
With systems that have multiple video cards, this option determines whether the primary
display uses a PCI slot or an AGP slot.
Options: Onboard/AGP (default)
、
PIC Slot
Onboard I/O Chip Setup
If you highlight the “Onboard I/O Chip Setup” label and then press the enter key, it will take
you to a submenu with the following options:
PWRON After PWR-Fail
Set if restart the system after power fail. Choose On, the system will start whether the
system was on before power failed. Choose Former-Sts, the system will restore to the status
before the power failed.
Options: Off (default)
、
On
、
Former-Sts
Power On Function
This option allows you to select a way to power on your computer.
Options: Password
、
Hot KEY
、
Mouse Left
、
Mouse Right
、
Any KEY
、
BUTTON ONLY
(default), and Keyboard 98
KB Power On Password
Supply a password that your system will use as part of the power-on sequence.
Hot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function key) to power on
your system.
Options: Ctrl-F1, Ctrl-F2…… Ctrl-F12
Onboard FDC Controller
Select “Enabled” if your system has a floppy disk controller (FDC) installed on the system
board and you wish to use it. If you install an add-in FDC or the system has no floppy drive,
select “Disabled” .
Options: Enabled (default)
、
Disabled
Onboard Serial Port 1
Select an address and corresponding interrupt for the first serial port.
Options: Disabled
、
3F8/IRQ4 (default)
、
2F8/IRQ3
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto
