Mainboard K8NF4X-AM2
14
CDIN
JP1
Assignment
Assignment
1
Pin 1-2 Closed
+5V
KB/ USB Power ON Disable (Default)
1
Pin 2-3 Closed
+5VSB KB/ USB Power ON Enabled
Note:
Close stands for putting a jumper cap onto two header pins.
Clear CMOS Jumper: JBAT
The “Clear CMOS” function is used when you are unable boot your system and need to reset
the BIOS settings (CMOS settings) back to the manufacturer’s original settings. This is also a
way to reset the system password if you have forgotten it.
JBAT
Assignment
Pin 1-2 Closed
Normal (Default)
Pin 2-3 Closed
Clear CMOS Data
Note:
Close stands for putting a jumper cap onto two header pins.
1. Turn off your system and disconnect the AC power cable.
2. Set JBAT header to OFF (2-3 Closed).
3. Wait several seconds.
4. Set JBAT header to ON (1-2 closed).
5. Connect the AC power cable and turn on your system.
6. Reset your new password.
Audio Configuration
CD-ROM Audio-In Connector: CDIN
The CD-IN connector is used to attach an audio cable to audio devices
such as CD-ROMs, DVD-ROMs etc.
Front Audio Connector: AUDIO
If your case front panel has audio ports, you can connect them to the Front Audio Header of this
mainboard. First, you must remove the jumper caps on this header and then attach the cables
from the front panel to the pins on this header. You can use both the front audio panel and back
panel audio simultaneously. If you are not using front panel audio ports, leave the jumper caps
on the header pins (Note: pins 5-6 and 9-10) to avoid problems with the back panel audio ports.
The following steps explain how to reset your CMOS
configurations when you forgot a system password.
