Albalá Ingenieros, S.A. HVD3001C04, Manual

Page: 13 / 30

Albalá Ingenieros | Manual HVD3001C04
3. INSTALLATION
THE HVD3001C04 MODULE CONTAINS ELECTRONIC DEVICES SENSITIVE TO
ELECTROSTATIC DISCHARGE. Always use antistatic bags clearly identified
with a high degree of shielding for storage and transportation.
The HVD3001C04 module is composed of two parts: one HVD3001P02 main board and
one XVD3000P10 rear board. Both parts must be installed in a UR3000 or UR3100
mounting frame following the instructions in the corresponding section of this chapter.
3.1. Initial inspection
Verify that the package has been properly handled during transport. After opening the
packaging, check that one HVD3001P02 main board and one XVD3000P10 rear board
are inside.
You must notify your Albalá Ingenieros distributor or dealer of any damage or defects
observed.
Follow the instructions in this manual to install this module in the mounting frame.
3.2. Safety instructions
When the module incorporates any optional SFP/SFP+ optic fiber transmitter provided by
Albalá Ingenieros, the HVD3001C04 is a CLASS 1 LASER product as per the IEC 60825-1
standard. Please read the safety instructions included in this manual carefully before
using this module.
• The HVD3001C04 may contain an SFP/SFP+ fiber optic transmitter module
with laser diodes. These modules are CLASS 1 LASER products. Due to its
features this device is inherently safe. However, exercise CAUTION as there
is invisible laser radiation in the module's fiber optic connectors. Avoid
exposure to the beam. NEVER lift or remove the cover of the HVD3001C04's
optical connectors except to connect a fiber optic connection, and be sure
that the power is off when doing so. NEVER leave optical connections that
are carrying signals disconnected from the equipment. NEVER examine a
fiber optic connector with a microscope without being absolutely certain
13