Section 4
Installation
4.1 Mounting
4.1.1 Mount the unit in locations that meet the following temperature and humidity requirements.
Do not expose to conditions outside of these ranges.
32 °C (90 °F) @ 93%
Humidity
0 °C to 49 °C (32 °F to 120 °F)
Temperature
Mount the unit in a standard 19" equipment rack using the supplied 10-32 X ¾" machine scre ws.
Locate an open 2RU slot in the rack and remove the filler panel(s) (if present)
Slide the unit into the open slot from the front of the rack
Install the four supplied 10-32 X ¾" machine screws into the end brackets of the unit
4.1.2 Removing the faceplate of the unit
To remove the faceplate of the RMMV Rack Mount Power Supply, remove the four screws at the
corners of the faceplate. Pull out gently on the faceplate to disengage the LEDs from the holes in the
faceplate.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
18
19
20
21
22
23
24
REMOVE FOUR
SCREWS
4.1.3 Replacing the faceplate of the unit
Gently slide the faceplate over the output LEDs and secure with the four screws previously removed..
RMMV Series Installation Instructions
7/13/2009, 10:26:56 AM
52-391 Rev A.02
Page 9 of 20
AlarmSaf
65A Industrial Way, Wilmington, MA 01887 978 658 6717 www.alarmsaf.com
