16
USERS (Continued)
; 6 :
6. Enable Total User Lockout Mode
(This Function enabled through keypad only)
7. Disable Total User Lockout Mode
(This Function enabled through keypad only)
; 7 :
User Lockout Mode
Prevents all User Codes (Except User 1 Code) from operating the lock.
Note:
No other programming
functions or schedules will re-enable Users. Users must be re-enabled with Function 7.
Note:
Does not change the User enable/disable status.
Note:
If the lock is currently in Passage
Mode (door "unlocked") and Function 6 is programmed, the lock will remain in Passage Mode.
M
5. User Enable with Timeout
(Enter Timeout, XXX Hours)
(This Function enabled through keypad only)
; 5 ;
[ _ _ _ _ ]
;
[ _ _ _ _ ]
:
(User Number) (XXX Hours)
With Function 5, User Numbers must be between 2-300, hours must be between 1-999.
Function 5 can
temporarily
override a disabled User (disabled using Function 3 above).
Since this is a temporary feature, Function 5 can only be enabled using the keypad.
Example:
Brian, User Number 157, rarely works at the office, but when he does, enable him for his 8 hour work day by
entering Program Mode and pressing:
;
5
;
157
;
008
:
.
NOTE:
Up to 4 Timeout Functions may be pending at any one time. An error beep will sound when attempting to program more
than 4 Timeout Functions.
2
Service Code is a One-Time-Only Code. Once it is used, it is disabled until enabled again.
NOTE:
User Number 297 is used to reset Service Code Use. See "Terminology Used in
this Manual" on page 6 for more information and examples regarding special Users 297-300.
; 9 :
9. Enable User 300
(Service Code)
2
2
; 1 0 ; 0 0 0 :
10. Erase All Users Except the Master Code
(User 1)
(This Function enabled through keypad only)
Erases all User Codes except the Master Code (User 1).
Function 10 can only be performed using the keypad.
M
11. Reserved
3. Disable User
; 3 ;
[ _ _ _ _ ]
:
(User Number)
4. Enable User
; 4 ;
[ _ _ _ _ ]
:
(User Number)
User Enable/Disable
(By User Number)
User Number must be between 2 and 300.
NOTE:
Will Enable/Disable Users even if the User is associated with an enabled Group. Use Feature 3 to disable a specific
User Number and their associated User Code. If the disabled User Code is entered, the lock will flash 1 Green and 4 Red Flash-
es (with 1 long and 5 short beeps) indicating that the User Code exists in memory, but is disabled. Function 4 will "undo" Func-
2
8. Reserved
Programming Functions (cont'd)