Alarm Controls Corporation KP-100A, Manual, Page: 9 / 32

SET KEYPAD IN PROGRAMMING MODE WITH ONE TIME MASTER CODE
- INITIAL SET UP ONLY
It is always necessary to set the keypad in programming mode for feature programming
The keypad is in normal operation after power-up delay. Set it in programming mode with Master
Code and validate it with .
MASTER CODE VALIDATION
NOTE:
a) For the owner’s convenience in programming at the first time, a one time Master Code 0 0 0 0 has
been put into the keypad beforeleaving the factory. It is
NOT
a default code. For security reasons,
owner must program a personal Master Code to replace it when the keypad is installed.
b) The Main LED (amber) is ON after the keypad confirms it in programming mode with 2 Echo
Tones. Now go to “Function 01” (page 12) and program in your new Master Code.
c)
DO NOT
turn off power while the keypad is in programming mode. Otherwise, it may cause an
error to the data in memory.
9
PROGRAMMING & OPERATION
POWER-UP THE KEYPAD
The keypad gives power-up delay of 1 minute after power has been applied. It is the time frame
designed for setting the keypad to programming mode with DAP code. See the details of
“DAP
CODE – 2 8 2 8”
below.
1) The keypad gives continuous Echo Tones for 1 minute after power-up.
2) The power-up delay can be stopped instantly with if the delay Echo Tone is found
unpleasent and setting the keypad to programming mode with DAP code is not required.
NOTE: Use this code only after a power outage
3) The keypad will set itself to Normal Operation Mode automatically after the 1 minute power-up
delay expired or it is stopped with .
1 2 #
POWER-UP DELAY STOP VALIDATION
12#
12#
ONE TIME