Alarm.com Smart Thermostat
Product Manual
| 3
• Before installing or servicing the thermostat,
turn off power to the system at the circuit
breaker.
• Leave power off until you have finished
installing or servicing.
• Shorting the electric terminals at the control
on the heating or cooling system may damage
the thermostat. Do not test the system this way.
• You must follow all local codes and ordinances
for wiring the system.
• This thermostat should only be powered by 4
AA alkaline batteries or a listed class 2 power
supply at 24 VAC (C-Wire or wall transformer).
• An amperage higher than 1 amp to each
thermostat relay load may cause damage to
the thermostat.
• Verify that the system is 24 VAC. If the old system
is labeled as 120 or 240 volts or has wire nuts,
the system is high voltage. Do not install the
thermostat to a high voltage system. Contact
a local HVAC professional for help.
