Alamo Industrial RX60, Operator'S Manual

Page: 47 / 166

ASSEMBLY
RX60/72/84 10/12 Assembly Section 3-3
© 2012 Alamo Group Inc.
ASSEMBL
Y
SHIELD ASSEMBLY (All Models)
SLIP CLUTCH SHIELD
1. To attach the Slip Clutch Shield
Guide shield bracket (2) through weldment shield
(1) so that bracket stud screw protrudes through
weldment hole and retain in place with wingnut (3).
2. Align holes of shield bracket with gearbox holes
positioned around input shaft. Retain bracket to
gearbox with three 3/8” x 3/4” bolts (6), 3/8”
washers (4), and 3/8” lockwashers (5). Posi-
tion hardware as follows: gearbox, bracket, flat-
washer, lockwasher, bolt. Tighten bolts to
recommended torque.
Figure Asm-R-0091.
TAIL WHEEL INSTALLATION
(Model RX60 & RX72)
Align Tail Wheel Beam Weldment (1) between pivot
brackets located behind gearbox mount on the
Mainframe Weldment.
NOTE: Long side of caster
fork pivot tube is positioned up. Attach the Tail
Wheel Beam Weldment (1) to the Mainframe
Weldment with one 5/8” Bolt (4), and 5/8” nut (5).
Slide Tail Wheel Beam Weldment (1) into Gauge
Wheel Mount Weldment (3) and retain with two 1/2”
x 1-1/2” bolts (6), and locknuts (7).
1. Insert the Caster Fork Weldment (11) into the
Tail Wheel Beam (1) and retain with Flatwasher
(9) and Cotter Pin (10).
2. Tighten all bolts to the proper torque. Figure
Asm-R-0408.