AL-MEISTER ALM3220 Instruction Manual <Rev.2>
Page 31 of 50
5. AUTOMATIC OPERATION (cont’d)
5-2-4. SET COUNTER
Press MODE key.
Move cursor by using UP or DOWN key.
Press MODE key to confirm.
[SET COUNT]
Set the number you want to laminate.
NOTE:
Defaults to MULTI after power outage.
[MARGIN SET]
Make cuts either with, or without margin.
NOTE:
Defaults to MARGIN ON after power outage.
[CUT ADJUST]
This parameter adjusts the cutting positions at the leading and trailing edges of each sheet.
NOTE:
These settings are retained in memory after a power outage.
[TOTAL COUNT]
Total Count indicates the accumulated number of laminations since the RESET button was pushed.
NOTE:
This record is retained in memory after a power outage.