AL-KO SOLO Robolinho 1200, Manual

Page: 62 / 432

GB
62 Robolinho 700/1200/2000
Help in case of malfunction
Fault code Cause Remedy
CN018: Cal: Colli-
sion
Fault during the calibration:
■
The appliance has
bumped into an obstacle.
Remove the obstacle.
CN038: Battery
The rechargeable battery is
flat:
Loop of the boundary cable
is too long, too many islands. Correct the location of the boundary ca-
ble.
When charging, no contact to
the charging contacts
■
Clean the charging contacts.
■
Place the appliance in the base sta-
tion and check that the charging
contacts make contact.
■
Have the charging contacts checked
and replaced by a service centre of
the manufacturer.
Obstacles close to the base
station Remove the obstacles.
The appliance has got stuck. Place the appliance on the free, desig-
nated grass surface.
The appliance does not find
the base station.
■
Check the boundary cable for dam-
age.
■
Have the boundary cable repaired
by a service centre of the manufac-
turer.
The rechargeable battery is
depleted. Have the rechargeable battery replaced
by a service centre of the manufacturer.
The charging electronics are
faulty. Have the charging electronics checked
by a service centre of the manufacturer.
CN099: Recov escape Automatic fault rectification
not possible
■
Manually acknowledge the malfunc-
tion message.
■
If the fault reoccurs: Have the appli-
ance checked by a service centre of
the manufacturer.
CN104: Battery over
heating
■
Rechargeable battery
has overheated (more
than 60 °C). No dis-
charging is possible.
■
Emergency switch-off by
monitoring electronic
control unit
■
Switch off the appliance and let the
rechargeable battery cool down.
■
Do not place the appliance on the
base station.
CN110: Blade motor
over heating
Mowing motor has overheat-
ed (more than 80 °C).
■
Switch off the appliance and let it
cool down.
■
If the fault reoccurs: Have the appli-
ance checked by a service centre of
the manufacturer.