7
o
Blank
: indicates
24
hours mode.
You can press (
) key to switch between
12/24
hour time modes.
7.
When the minutes digits are flashing, set the required value then press (
), at
this time the date and time will be stored and AL-Muzakkira will return back to
the normal operation mode.
Notes
:
In case of setting a wrong value, you have to readjust AL-Muzakkira and
repeat the steps in "
How to set the time and date
" paragraph.
If you are adjusting the time and date, you can go back to the normal
operation mode without saving changes by pressing (
) key.
As you have finished adjusting AL-Muzakkira, check the status of the
AM/PM indicators.
Pay attention to adjust the time and date precisely (every three months)
because this affects the prayer and Iqama times.
AL-Muzakkira calculates the Hijri date according to the Georgian date
automatically, so make sure to adjust it accurately.
8.2
Adjusting the Hijri date:
If the Hijri month endings which are calculated by AL-Muzakkira don't match the
actual Hijri month endings, you can adjust the Hijri date without entering the time
and date adjusting program as follows:
When AL-Muzakkira is in the normal operation mode; press and hold (
)
continuously, AL-Muzakkira will display three consecutive probabilities of the Hijri
date (the calculated Hijri date plus one day, the calculated Hijri date, and the
calculated Hijri date minus one day), release (
) at the actual date.
8.3
Adjusting the summer/winter time modes:
AL-Muzakkira
switches automatically between the summer/winter time modes at the
beginning of April and October (or November).
In case of it’s necessary to switch between summer/winter time modes manually (in a
date different from those mentioned above), press (
) key to increase/decrease the
time, the prayer times, and the sunrise time by one hour.
8.4
The date displaying modes:
AL-Muzakkira
has three modes for displaying the date:
1.
Switching between Hijri/Georgian dates every five seconds.
2.
Displaying the Hijri date only.
3.
Displaying the Georgian date only.
In order to switch between the three displaying modes; press (
) key.
