Akuvox X933H, Manual

Page: 88 / 130

X933H Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com 78
Parameters Set-up:

Any Device Activated: To select which type of detection device is,
including CO Sensor, Gas Sensor, Door/Window Sensor, Emergency
Button, Motion Sensor, Smoke Sensor, Flood Sensor, etc.

Alarm Siren: switch on or off the alarm siren according to your need.
when you switch it off, the alarm will not go off when the alarm is
triggered.

Send Message: enable the or disable the SIP message feature. if you
enable it, the SIP message will be sent to the device or app with
pre-defined SIP account, for example your app for the notification.

Send HTTP: enable this feature when you want to send the
pre-configured HTTP command to the designated device or server for the
corresponding actions.

Defence delay : It means when users change the arming mode from other
modes, there will be a few seconds delay time to get activated. You can
customize the delay time from 0-90s.

Alarm delay : It means when the sensor triggered, there will be a few
seconds delay time to announce the notification. You can customize the
alarm delay time 0-90s.

Status : To enable or disable Arming mode on the corresponding Zone.
15.2.4. Configure Alarm Text
After the alarm sensor is set up, you are allowed to customize your alarm text
shown on the screen when an alarm is triggered on web Arming> Zone
Setting > Customized Alarm interface. Enter the alarm text for each device
according to your need.