background image

 

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany 

www.AKTOBIS.de

 

Email: [email protected] 

 
 
3.  Cleaning 

 

3.1 Preparation for cleaning 
 

  Please switch off the appliance first and disconnect the mains plug before cleaning 

the humidifier. 
 

  Open the upper lid of the humidifier and first remove the white water tank and the 

black steam nozzle shaft incl. steam nozzle. 
 

  Now unscrew the residual water drain (see illustration on the right), which is 

located on the lower rear side, and empty the appliance completely of any residual 
water. 
Note: It is best to place the appliance in a sink to empty it, as up to one litre of 
residual water can still run off ! 

 

3.2 Cleaning the housing and the wet area 
 

  Only use mild cleaning agents to clean your humidifier. 

 

  Rinse the white water tank carefully and wipe it from the outside with a damp cloth. 

 

  Next, clean the black steam nozzle shaft incl. the steam nozzle. 

 

  Now carefully clean the white water cup incl. the ultrasonic water vapour unit in the lower part of your machine. 

 

Notes: In the case of hard water (the tap water contains too much calcium and magnesium), limescale deposits 
can occur in the humidifier and especially in the water cup. These limescale deposits in the unit and especially 
in the area of the evaporator and the water vapour unit can lead to impaired functioning. We therefore 
recommend that you 

 

Clean the evaporator and the ultrasonic water vapour unit every week. 

 

Change the water in the water tank regularly to keep it fresh. 
 

The ultrasonic water vapour unit itself is made of silver metal and has three approx. 2 cm large evaporators 
(eyes) on the top. 

 

a.)  Add 5-10 drops of a suitable cleaning agent (e.g. Dimanin A* 

available in any pharmacy*

) to the surface of 

the vaporisers or also to the remaining area of the water cup and wait a few minutes. 

b.)  Then carefully wipe off any flakes of dirt (limescale) from the 

surfaces with a soft sponge or the enclosed brush (see 
illustration on the right). 
Note: Never clean the evaporators with objects made of metal 
or blunt material! This would damage the evaporators. 

c.)  Finally, rinse the evaporator / water cup well with clear water. 
 

  With the exception of the electrical control panel, all parts of the 

humidifier can be wiped or cleaned with a soft damp cloth when the 
unit is switched off. 

 

  Remove any water, clean the unit thoroughly and dry it well if you are not going to use the humidifier for a long 

time. 

 

 
 
 
 
 
 
 
 
 

Summary of Contents for WDH-MG1











Reviews: