Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
Email: [email protected]
Cleaning:
Always disconnect the mains plug before cleaning your air conditioner !
To keep the effectiveness and service life of your air conditioner high, please clean this unit regularly !
Cleaning the housing:
Use a soft and damp cloth to clean the housing of the air conditioner. Please do not use aggressive cleaning
agents, they may damage your unit !
Cleaning the filters (does not apply to the activated carbon filter net):
Use a hoover to clean the filters or tap them out gently.
Alternatively, you can rinse the filters under running water. Please make sure that the water is no hotter than 40°C.
Allow the filters to dry completely before putting them back into the appliance !
Note: Please never operate the air conditioner without a filter !
Stow the air conditioner:
Empty any condensation water from the condensation tank.
Let the unit run in ventilation-only mode for a few hours to allow it to dry completely
from the inside.
Clean the filters.
Pull out the mains plug and stow it in the mains plug compartment provided (see
adjacent illustration).
Use the original carton to store the air conditioner.
Troubleshooting:
The unit does not switch on:
Check the mains plug and try a different socket.
Check if the house fuse has popped out.
Check whether the condensation tank is full ("Water Full" signal light is on). If the condensation tank is full,
empty it (see page 9).
Check whether the room temperature is perhaps already below the selected target temperature.
It could be that the overheating protection of the unit is switched on. In this case, try again after a short while
and in cooler conditions.
The unit does not cool enough:
Make sure that the unit is not in direct sunlight.
Make sure that no windows or doors are open.
Is it possible that there are too many heat sources in the room? Please consider that every person, every
window exposed to sunlight and every electrical appliance produces heat and therefore the cooling capacity of
the air conditioner may no longer be effective enough.
Make sure that the filter is not dirty and is sufficiently permeable to air.
Make sure that the air intake, the exhaust air and the exhaust air duct for the warm air are not blocked and
have sufficient free space.
Check whether the room temperature is perhaps already below the selected target temperature.
Power plug
compartment
Power plug
compartment
