Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
Email: [email protected]
Directions for use:
1. Commissioning
1.1 Insert the power plug properly into the power outlet.
1.2. Check that the condensation tank is properly seated in the dehumidifier. (When using the dehumidifier for the
first time, it is possible that the "condensation tank full" light is illuminated. Simply pull the condensation tank
out briefly and then push it right back in again and you are ready to go! )
1.3 Switch on the device with the operating switch (on/off button). Now press the humidity setting button and set
your target humidity as desired. The target value "CNT" corresponds to continuous operation ! The value you
set must be below the current room humidity for the unit to dehumidify. If your value is above the current room
humidity, the fan runs for 3 minutes and the unit then switches off. If the room humidity rises above the set
value, the device automatically starts dehumidification operation again.
1.4 Use the air circulation adjustment button to select between low and high fan speed / air circulation.
1.5 If you want to activate/use the timer function (function for determining the remaining time or function for
specifying a start time), press the TIMER button.
Determining the remaining run time: Press the TIMER button during operation to select the desired remaining
run time of the dehumidifier. (A value between 1 - 24 hours can be selected). After this selected operating time
has elapsed, the device switches off automatically.
Determining a start time: When the dehumidifier is switched off, press the TIMER button to select the desired
start time. (A value between 1 - 24 hours can be selected). After this selected time has elapsed, the appliance
switches on automatically (with the last settings used, provided the mains plug has not been disconnected in
the meantime).
1.6 If you want to use the laundry drying mode, press the button to activate the laundry drying mode. In the laundry
drying mode, the air circulation is continuously set to high.dehumidified. The appliance operates in continuous
mode here. Exit the laundry drying mode by pressing
pressing the button again to activate the laundry drying mode.
1.7 In the air circulation mode ( air purification ) only the fan operates and no dehumidification takes place.
Start and stop this setting, by pressing the button to activate the
Air circulation mode (air purification).
2. Emptying the collection tank / When the "Condensation tank full" light is on
When the condensation tank is full, the signal light comes on and the dehumidifier then
automatically stops its dehumidification operation. Remove the condensation tank and empty
it. After you have pushed the condensation tank neatly back into the device, the
dehumidification operation starts again automatically.
3. Connecting a hose
3.1. You will need a ½ inch plastic hose.
3.2. Remove the condensation tank for a short time.
3.3. Pass the plastic hose through the opening above the condensation tank and then connect it to the drip tap (see
diagrams below). Then push the condensation tank neatly back into the appliance.
