Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
Email: [email protected]
8.) Setting the fan strength (air circulation)
Press the Speed button in succession for the desired setting. The unit has three fan speeds:
Level 1
= Weak fan strength (air circulation)
Level 2
= Medium fan strength (air circulation)
Level 3
= Strong fan power (air circulation)
9.) Night operation / night mode
Press the speed button permanently for approx. 3-5 seconds. This switches off the touch panel display and
the unit jumps to an extremely low-noise fan strength !
To cancel the night mode again, simply press the button area of the touch panel display again.
10.) Timer (timer)
Press the timing button for approx. 3 seconds until zero (0) starts flashing in the display field. Now you can
select a value between 0 - 12 hours by pressing repeatedly. After you have selected your desired value, wait for
approx. 5 seconds until you hear an acknowledgement tone and the display field shows the current temperature
and humidity value again. Now the remaining time is stored and the air purifier switches off automatically after this
time has elapsed.
The remaining time is displayed alternately with the current temperature and the humidity value. In addition, you
can also display the remaining time by briefly pressing the timing button.
To reset the remaining running time, simply press the timing button continuously for approx. 3 seconds until the
acknowledgement tone sounds. This switches off (zeroes) the remaining running time and the air purifier works in
continuous operation again.
11.) Filter change indicator
The air purifier has a filter change indicator.
The display is always lit by default, after an active runtime (operating time) of 1,440 hours, the left symbol starts
flashing and recommends that you now change the combi-filter (activated carbon and catalyst filter).
After an active runtime (operating time) of 2,880 hours, the right-hand symbol starts flashing and recommends that
you now change the HEPA/ULPA filter.
Note: The filter change indicator is time-controlled and depending on the type of use of the air purifier, it may be
necessary to replace the filters earlier (before the filter change indicator is triggered) !
After you have replaced the filters, press the reset button permanently until you hear a long acknowledgement
tone. Now the flashing filter change indicator is reset and the internal filter runtime count starts again.
12.) Cleaning & Storage
Please always disconnect the mains plug first and allow the air purifier to drain completely before carrying out any
cleaning activities on your unit !
