www.tmatlantic.com
- 22 -
Warning
To avoid electric shock, disconnect the test leads when the rotary switch is in the MEM position.
Notice
In MEM function, each operation could only read or clear the data of one storing part.
2. Turn the rotary switch to the MEM position and “
” displays on the screen.
3. Press pushbutton to select a storing data.
Press
for saved reading, “
MEM
” appears in the display.
Press
for logged reading, “
LOG
” appears in the display.
Press
for comparative reading, “
COMP
” appears in the display.
4. Press
or
to view the sequent or the previous recording.
5. Turn the rotary switch to any other position to enter measuring mode.
Clearing Memory
Use the following procedure to clear memory data:
1. Disconnect the input leads at the measurement source.
Warning
To avoid electric shock, disconnect the test leads when the rotary switch is in the MEM position.
Notice
In MEM function, each operation could only read or clear the data of one storing part.
2. Turn the rotary switch to the MEM position.
3. Press pushbutton to select a storing data to clear.
Press
to clear saved reading, “
MEM
” appears in the display.
Press
to clear logged reading, “
LOG
” appears in the display.
Press
to clear comparative reading, “
COMP
” appears in the display.
4. Press
for more than 2S, “
” appears in the display and press
again to clear the type of memory presently; or
else press
to cancel.
Using Communications
Notice
Make sure your PC has been connected with the earth ground when employing this function.
When using a PC-to-meter IR (infrared) communication link, refer to the DMMVIEW_A Software Guide or the on line help.
You can use the USB to UART Bridge Controller and DMMVIEW_A software to transfer the contents of a meter to a PC.
