
07/2015
Temperature Difference Controller TDC 3
Page 22 of 47
E.2 Commissioning help
E.3 Free commissioning
If you decide not to use the commissioning help, you should make the necessary settings
in the following sequence:
- Menu 10.
Language (see 14.)
- Menu 7.2
Time and date (see 12.2)
- Menu 7.1
Program selection (see 12.1)
- Menu 5.
Settings, all values (see 10.)
- Menu 6.
Protective functions if adaptations are necessary (see 11.)
- Menu 7.
Special functions if additional changes are necessary (see 12.)
Finally, menu 4.2 under operating mode “Manual“ should be used to test the switch outputs with
the consumers connected, and to check the sensor values for plausibility. Then switch on
automatic mode.
The first time the controller is turned on and after
the language and time are set, a query appears as
to whether you want to parametrize the controller
using the commissioning help or not.
The commissioning help can also be terminated or
called up again at any time in the special functions
menu. The commissioning help guides you through
the necessary basic settings in the correct order,
and provides brief descriptions of each parameter
in the display.
Pressing the “esc” key takes you back to the
previous value so you can look at the selected
setting again or adjust it if desired. Pressing the “esc” more than once takes you back step by
step to the selection mode, thus cancelling the commissioning help. Finally, menu 4.2 under
operating mode “Manual” should be used to test the switch outputs with the consumers
connected, and to check the sensor values for plausibility. Then switch on automatic mode.
Caution
Observe the explanations for the individual parameters on the following, pages,
and check whether further settings are necessary for your application.
Caution
Observe the explanations for the individual parameters on the following pages,
and check whether further settings are necessary for your application.