[AKD4128A-A]
[KM104301]
2010/09
- 30 -
[Write]: Data Writing Dialog
It is for when changing two or more bits on the same address at the same time.
Click [Write] button located on the right of the each corresponded address for a pop-up dialog box.
When checking the checkbox, the register will be “H” or “1”, when not checking the register will be “L” or ”0”.
Click [OK] to write setting value to the registers, or click [Cancel] to cancel this setting.
Figure 10. Window of [ Register Set ]
[Read]: Data Read
Click [Read] button located on the right of the each corresponded address to execute register reading.
After register reading, the display will be updated regarding to the register status.
Button Down indicates “H” or “1” and the bit name is in red (when read only it is in deep red).
Button Up indicates “L” or “0” and the bit name is in blue (when read only it is in gray)
Please be aware that button statuses will be changed by Read command.
Summary of Contents for AKD4128A-A
Page 49: ...AK4128A A Rev 0 部品面シルク図 AKD4128A A Rev 0 Evaluation Board ...
Page 50: ...AK4128A A Rev 0 半田面シルク図 ...
Page 51: ...AK4128A A Rev 0 部品面パターン図 ...
Page 52: ...AK4128A A Rev 0 半田面パターン図 ...
