6
b)
Paper feeding may be affected if the sheets are rolled or bent upward. Do not place in tray until it
it is flattened.
c)
Do not place papers of different thicknesses or materials at the same time, or paper feeding may
be affected.
d)
Do not use plastic sealed paper, film coated paper, PVC paper, and those too thick or too hard,
which may cause damage to the cutter.
10)
Paper Feeding and Cutting
WARNING!
Keep hair and hands away from the paper feeding and cutting areas to avoid injury.
WARNING!
Do not take anything out with your fingers at paper feeding and cutting areas.
11)
To Select Cutting Mode for 3.5” x 2” 10-up Preset:
If your LCD Screen is already set at “3.50 x 2.00” and shows “10pcs” at the top left, you are already in the
this preset mode. If you are not, do the following:
Press [Mode Changeover] key once. Press [Start ( + )] key til your LCD Panel shows “Card Size: 3.50 x 2.00”.
Please note there are two 3.5 x 2” Presets, one for 8-up and one for 10-up. To check which one you have,
press Mode Changeover key and check the Set Pieces field as below:
If you see the “8” like above, you are in the 3.5” x 2” 8-up Preset Mode. To get to 10pcs, press [Mode
Changeover key] once. Press [Start (+)] key once, to go to the next preset mode. The Card Size will still
read “3.50 x 2”. Press Mode Changeover. Your Set Pieces should now be at “10” as below:
a)
You are now in the 3.5 x 2” 10-up preset mode. Press the [Start] key and the machine will begin
cutting. The machine will automatically stop at the end of cutting and stay in the standby state.
Press the key again to start another cutting.
b)
To set up automatic feeding, follow instructions “To Set Pieces To Be Cut. (pg 9)” For example, if
cutting 100 cards, then Set Pieces should be set to “100pcs”, with 10 sheets in the feeding tray.
Then Press the [Start] key and the machine will begin cutting and finish once the set pieces have
finished being cut.
c)
At the end of cutting, please turn off power.
Mode
Changeover
Mode
Changeover
Summary of Contents for Cardmac Pro
Page 18: ...3 5 x2 ...
Page 19: ......
Page 20: ......
Page 21: ...T e mp l a t eD i me n s i o n sf o r C u s t o m L e n g t hC a r d s ...