4
Insert batteries in accordance with instructions:
Insert the batteries with correct polarities (positive
and negative
).
Incorrect polarities may cause breakage and leakage of the
batteries, hurt operators and contaminate the remote controller.
Do not block or cover the vents:
Blocking the vents may cause overheating and fire. Do not install the
product in a place with little or no ventilation. Never cover the vents
with towels, blankets or dusters.
Unplug the connector:
Unplug the power connector when the product will not be used
for a long time.
ATTENTION
Unplug the connector
Hold the power connector when removing the power cable:
Pulling the power cable itself may damage the wires inside the cable
and cause fire or electric shock.
Do not touch the connector with wet hands:
To avoid risk of electric shock.
Unplug the connector
The power cable should be kept away from heat sources:
The heat produced by any heat source may melt the covering of the
power cable.
Always make sure the antenna system is properly grounded to provide adequate
protection against voltage surges and built-up static charges.(see Section 810 of the
National Electric Code.)
Antenna lead-in wire
Antenna discharge unit
(NEC Section 810-20)
Grounding conductors
(NEC Section 810-21)
Power service grounding
electrode system (NEC Art 250 Part H)
Ground clamp
Electric service equipment
Ground clamp
Use extreme care to make sure you are never in a position where your body (or any
item you are in contact with, such as a ladder or screwdriver) can accidentally touch
overhead power lines. Never locate the antenna near overhead power lines or other
electrical circuits. Never attempt to install any of the following during lightning activity:
a). an antenna system; or b).cables, wires, or any home theater component connected
to an antenna or phone system.
Summary of Contents for LCT2765TD
Page 1: ......
