29
Note: It will be invalid if the current source is not
TV.
■
Selecting Channel
Press CH +/- button on the remote control to search the channels, the channel number will
increase or decrease by 1 for each pressing excluding the skipped channels.
Press number buttons 0~9 to select the corresponding channel content. If the channel number
is bigger than 9, just press the two number buttons successively. If the channel number is
bigger than 100, just press the three number buttons successively. The time interval should not
exceed 2 seconds.
If the channel number you pressed is bigger than the maximum channel number that the
setting is permitted, the maximum numbered channel content will be remained.
■
Channel Preview
Press Recall button to switch between present channel and previous channel. (Only for TV)
Hot keys:
-
You can also press Recall button on the remote control.
◆
Using the Geometric Menu
Note:
If your current input source is “VGA” , push Menu button enter into this menu. It is not available
in other input source mode.
When smart picture mode is pre-set, the value of the above settings will be different
according to different input source.
Press Menu button on the remote control,
and then press
＜
or
＞
button until the
“Geometric” menu appears.
Press
∧
or
∨
button to highlight the item.
Press Enter button to confirm and display
a status bar as below.
Press
＜
button to decrease that will soften
the color. Press
＞
button to increase that
■
Using “Contrast”
will make white area more bright.
Press Enter button to confirm the adjustment and return.
cursor to “Cancel” and press Enter button
for close this setting.
Press
＜
button to return.
Hot keys:
-
You can also press CH.Edit button on the remote control.
