Akai AMP-10, User Manual

Page: 55 / 58

54
TROUBLESHOOTING GUIDE
Symptom Possible Cause
Station not tuned properly for
FM or MW.
FM: Wire aerial is not
positioned correctly .
Loop aerial is not positioned
correctly.
FM station is mono or station
signal is weak.
Function is not set to Tuner.
Volume at minimum.
Solution
Retune FM or MW broadcast
station.
Extend FM wire aerial.
Reposition so that the best
reception is obtained.
Extend FM aerial. Try other
strong stations.
Press MODE button to select
Tuner function.
Increase Volume.
Radio
Noise or sound
distorted on FM or
MW broadcasts.
FM STEREO indicator
does not light.
MW or FM, no sound.
iPod
®
Player
Unit does not respond
(no power)
AC adaptor is not plugged into a
wall outlet or the connector is not
plugged into the DC IN jack
on the back of the unit.
Plug the AC adaptor into a wall
outlet and plug the connector into
the DC IN jack on the unit.
Make sure the dock insert is the
proper fit for the iPod ®
.
Remove the iPod ® from the dock
and check for obstruction on the
connections in the dock and on the
iPod
®
,Then reseat it in the dock
.
Remove the iPod
®
from the dock
and check for obstruction on the
connections in the dock and on the
iPod ® ,Then reseat it in the dock
.
Please make sure your iPod
®
is
working properly before docking
into the unit. Please refer to the
iPod ® manual for details.
This unit cannot control those
iPod
®
or other devices.
Please make sure your iPod
®
is
working properly before docking
into the unit. Please refer to the
iPod ® manual for details.
Remove the iPod ® from the dock
and check for obstruction on the
connections in the dock and on the
iPod ® ,Then reseat it in the dock
.
iPod
®
does not
dock porperly
Using no or wrong iPod ®
insert
iPod
® did not install properly
iPod ® does not
respond to the unit.
iPod ® is not installed
properly
iPod
®
is locked up
Using first or second generation
iPod ® , iPod ® Shuffle or
other devices.
iPod ® did not
charge up
iPod
®
is not installed
properly
iPod
®
is locked up/frozen
iPod
®
battery has problem
Remarks:
If troubleshooting(see above)does not eliminate the problem, disconnect the unit from the
main power and re-connect after a few seconds. Resetting causes the unit to restore its
factory default setting and results in all the setting made by the user being deleted.