Akai AMP-10, User Manual

Page: 51 / 58

When connecting an iPod ® / iPhone to this iPod ® Dock, please ensure that the
correct adaptor plate is used. FAILURE TO DO SO MAY RESULT IN DAMAGE
TO THE iPod
® / iPhone.
To place a dock adaptor:
1. Refer to the compatibility table below and select the correct
dock adaptor for the iPod
®
/ iPhone.
2. Place the proper adaptor into the dock and press it into
position. The adaptor will only go in one way. The iPod
®
dock connector should fit through the opening in the
bottom of the adaptor.
3. Carefully align and then gently insert the iPod
®
/ iPhone into
the dock. (The iPod
®
/ iPhone must not be in a case or “SKIN”)
4. To remove/replace a dock adaptor, first remove the iPod
®
/ iPhone,
then grip the adaptor and pull gently upwards.
Charging your iPod
®
/ iPhone
Note: Please make sure you are using the correct insert for your iPod
®
/ iPhone and that it is
properly docked into this unit.
FAILURE TO DO SO MAY DAMAGE THE iPod ® / iPhone.
When an iPod
®
/ iPhone is inserted into the dock, it will go to standby mode then turn off. While
the iPod
®
/ iPhone is docked in the system, it will recharge (until fully charged). Please note that
older 3rd generation iPod
®
cannot be charged by this unit.
NOTE
: In order to avoid interfering with the reception, the iPod
®
/ iPhone will not be charged in
the TUNER mode(FM / MW).
iPod
®
/ iPhone OPERATIONS
Choosing The Correct Adaptor
50
This iPod
®
Dock comes with 6 removable dock adaptors. Using the correct adaptor ensures
the proper fit for your iPod
®
/ iPhone and helps to reduce the stress on the connector when
operating the iPod
®
/ iPhone.