iPod
®
/iPhone OPERATIONS
49
This AKAI system includes two separate docking stations so that you can dock and charge two
separate iPod
®
models, or one iPod
®
and one iPhone model simultaneously. Since this model
is ‘Works With iPhone’ certified it is not necessary to place your iPhone in the Airplane mode
to avoid audio interference. You will be able to make and receive calls, without interference,
while the system is in operation.
Use the left side dock for any docking iPod
®
model. Use the right side dock for any docking
iPod
®
model or any iPhone model.
IMPORTANT NOTES:
A.
B.
This system is supplied with 6 different iPod
®
adaptor/inserts intended to insure that older
iPod
®
models fit properly in the docking area. If your iPod
®
was supplied with a docking
adaptor at the time of purchase, that adaptor will fit properly into the docking area of this
system. If you have an older iPod
®
model that was not supplied with a docking adaptor, please
select the appropriate adaptor from the chart below. Each adaptor is identified by the letters
“A” through “F” on the bottom of the adaptor. Select the adaptor with the letter that
corresponds to your iPod
®
model. Position the adaptor in the docking area as shown and
make sure that it ‘locks’ in place, then place your iPod
®
into the adaptor and make sure that
the iPod
®
connector on this system is fully inserted into the slot on the bottom of your iPod
®
.
When properly docked your iPod
®
should be ‘leaning backward’ slightly on a 15 degree angle.
DO NOT ATTEMPT TO “STRAIGHTEN” YOUR IPOD
®
. THIS COULD RESULT IN DAMAGE
TO THE DOCKING CONNECTOR OR DAMAGE TO YOUR IPOD
®
.
The right side dock labeled iPod
®
/iPhone has priority in this model. If you are playing an
iPod
®
in the left side dock labeled iPod
®
and you insert an iPhone or iPod
®
in the right
side dock, the system will automatically switch to the iPod
®
or iPhone in the right side
dock.
When you dock an iPhone or certain newer iPod
®
models in either dock there may be a
delay of several seconds before the system recognizes the device and the main menu is
displayed. This is because the system and the docked device must go through an
‘Authentication Process’ before the docked device can accept any commands. THIS IS
NORMAL AND NOT AN INDICATION OF ANY PROBLEM WITH YOUR SYSTEM.
Remote the iPod
®
adaptor (E,F) illustration
Press its inside rear surface and pull it upward.
Summary of Contents for AMP-10
Page 58: ...AMP 10 www akai france com ...
