After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | [email protected]
9
Installation (Cont.)
Installing the drain hose
• The drain hose and drain pump filter are located at the back of the machine, as
illustrated below, left.
• Pinching the two bands of the clamp on the drain hose, connect it to the drain hose
connection at the back of the washer, as illustrated below, right.
Drain pump with
lint filter
Drain hose
connection
IMPORTANT!
• Never lay down the drain hose, as water will be discharged.
• When the washer is in use, put the drain hose into a drain spout (or into a sink/tub),
as illustrated below.
• Make sure the height of the drain hose is at least 86cm, otherwise the washer will
not work well, or the water may flow out in the course of washing. Also ensure the
drain hose is not higher than 100cm above ground, otherwise the washer will not
drain water well.
• Be sure the drain hose is properly routed so it will not kink or lift off the sink.
