AJAX MotionProtect, User Manual, Page: 5 / 16

Request for connection to the hub is transmitted for a short time at the moment
of switching on the device.
If the detector failed to connect to the hub, switch off the detector for 5 seconds
and retry.
The connected detector will appear in the devices list in the application. Update
of the detector statuses in the list depends on the device inquiry time set in the
hub settings(default value is 36 seconds).
Connecting the Detector to Third Party security systems
To connect the detector to a third party security central unit with the
or
integration module, follow the recommendations in the
manuals of these devices.
States
Parameter Value
Temperature
Temperature of the Detector. Measured on the
processor and changes gradually
Jeweller Signal Strength
Signal strength between the hub and the
detector
Connection
Connection status between the hub and the
detector
Battery Charge
Battery level of the detector, displayed in
increments of 25%
Lid
The tamper mode of the detector, which reacts
to the detachment of or damage of the body
Delay when entering, sec Delay time when entering
Delay when leaving, sec Delay time when exiting
Routed through ReX
Displays the status of using the ReX range
extender
uartBridge
ocBridge Plus
1. Devices
2. MotionProtect | MotionProtect Plus