The detector should be installed at the recommended height to ensure the correct
operation of the pet immunity function. To install the SmartBracket mount on ties,
first make holes in it.
2. Install the detector on the SmartBracket panel.
3. Leave the detector detection zone (horizontal angle of view — 90°) and
make sure there is no movement within the detector field of view. This is
necessary for correct calibration of the masking sensors. During the
calibration, the detector will flash green around once per second. Calibration
takes up to 2 minutes.
The masking sensors calibration starts automatically as soon as the detector body
is attached to SmartBracket.
4. Perform Signal Strength and Attenuation tests. If the signal strength is
unstable or one bar is displayed, move the detector or hub.
5. Run detection zone tests, first for the lower sensors and then for the upper
ones. This will help determine and set the required maximum detection
distance of the detector (determined by the lower sensor). Then, run the
detection zone test for both sensors simultaneously, as well as the masking
sensors test. If there is no response to movement, select the appropriate
sensitivity level, detection distance (Detection Distance scrollbar), and
check the tilt angle of the detector.
6. Attach the SmartBracket mounting panel to the surface using the bundled
screws. When attaching, use at least two fixing points. To make the tamper
react to attempts to detach the device, be sure to fix the perforated corner of
SmartBracket.
Ties or double-sided adhesive tape should be used for temporary attachment only.
The device attached by adhesive tape may come unstuck from the surface and fall
at any time. In addition, the device may fail if hit. Note that while the device is
secured with ties or adhesive tape, the tamper will not trigger if the detector is
detached from the surface.
Summary of Contents for MotionCam
Page 32: ......
