www.aja.com
55
FS4 Frame Synchronizer/Converter v1.1
In the
Dual Stream
setting, the FS4 assumes both channels of Dual Stream 3G video are
muxed onto a single wire at the SDI1 input. The SDI 2 video signal is then taken internally
from the SDI 1 Stream B signal instead of the SDI2 In connector.
The following table shows the selections and their results. In the table, SDI1-A and SDI1-B
are the two muxed streams entering the SDI1 Input.
See
"Figure 12. Four Channel Mode, Dual Stream Inputs on page 36"
Channel Mode, Dual Stream Input on page 41"
for more information.
4.3, 4.5, 4.7
SDI3/5/7 3G Detect
This parameter configures 3G operation of the SDI 3, 5, and 7 video input, using settings
similar to
“4.1 SDI1 3G Detect” on page 54
4.4, 4.6, 4.8
SDI4/6/8 Input
Protect
This parameter allows you to protect Input SDI 4, 6, and 8 from being taken by a
Dual
Stream
selection, using settings similar to
“4.2 SDI2 Input Protect” on page 54
5.1 VidProc Bypass
(4Ch only) This parameter routes the input signal assigned to each video processor to the
output of that video processor (e.g. - Vid1 outputs are SDI1 and SDI5). All video processor
input SDI signals must be locked to each other and the Genlock Source must be set to
one of the SDI inputs assigned to a video processor input.
CONFIG Menu Group
The CONFIG Menu Group includes parameters for setting up the FS4’s network, system
name, SNMP, alarm, and screen saver configurations.
1 System Name
This parameter defines a unique name for the FS4. This same name is used both when
displaying systems via the web interface and when displaying the FS4’s screen saver.
SDI-3G Detect Setting
SDI2 Input Protect
Setting
1 Video Input
Setting
Resulting Input to
Crosspoint Matrix
3G-LvlB-DS signal
Dual Stream
setting, or
Auto Detect
with ANC Dual Stream data
Dual Stream
SDI1
SDI1-A
SDI2
SDI1-B
Normal
SDI1
SDI1-A
SDI2
SDI2
3G-LvlA signal
1080p 50/60
setting, or
Auto Detect
with ANC 1080p data, or
Auto Detect
with no ANC data
Dual Stream
SDI1
SDI1
SDI2
SDI2
Normal
SDI1
SDI1
SDI2
SDI2
Off (default)
On
Video Processor(s) operate normally.
Video Processor(s) are bypassed.
Variable
Set the system name, up to 20 characters.
Default:
aja-fs4