Aiwa XR-M700, Service Manual

Page: 33 / 46

– 33 –
41 RFSM O Output for RF.
42 RFS– O For setting RF gain and 3T compensation constant together with RFSM.
43 SLC O
SLICE LEVEL CONTROL; output for controlling the data slice level of DSP with
RF waveform.
44 SLI I Input for controlling the data slice level of DSP.
45 D-GND – GND for digital system.
46 FSC O Output pin for focus search smoothing capacitor.
47 TBC I (Tracking Balance Control) EF balance variable range setting pin.
48 NC – Not connected.
49 DEF O Output for disk defect detection.
50 CLK I Standard clock input; DSP's 4.23MHz is inputted.
51 CL I Clock input for microcontroller command.
52 DAT I Data input for microcontroller command.
53 CE I Chip-enable input for microcontroller command.
54 DRF O Detect RF; output for RF level detection.
55 FSS I
(Focus Search Mode) = search against reference voltage switching pin.
(Not used)
56 VCC2 – VCC pin for servo and digital systems.
57 REFI I For connecting pass capacitor to reference voltage.
58 VR O Reference voltage output.
59 LF2 – For setting disk defect-detection time constant.
60 PHI – Connects to capacitor for RF signal peak hold.
61 BHI – Connects to capacitor for RF signal bottom hold.
62 LDD O Output for APC circuit.
63 LDS I Input for APC circuit.
64 VCC1 – VCC pin for RF system.
Pin No. Pin Name I/O Description