– 2
2
–
Description
Pin No.
Pin Name
I/O
39
EFLG
O
C1, C2 error correction monitor pin. (Not used)
40
TEST
I
Test input pin. (Connected to GND)
41
EMPH
I/O
Emphasis pin. Which becomes an input pin after reset and can be controlled externally. This
becomes an emphasis monitor pin under control by command. (Not used)
42
MUTEL
O
L channel mute output pin. (Not used)
43 MUTER — R channel mute output pin. (Not used)
44 LVDD — L channel power supply pin.
45
LCHO
I
L channel output pin.
46 LVSS — L channel ground pin.
47
RVSS
O
R channel ground pin.
48
RCHO
I
R channel output pin.
49
RVDD
O
R channel power supply pin.
50
XVDD
O
Crystal oscillator power supply pin.
51
XIN
I
Connections for a 16.9344MHz crystal oscillator pin.
52
XOUT
O
53
XVSS
I
Crystal oscillator ground pin.
54
ASLRCK
I
L/R clock input pin. (Connected to GND)
55
ASDACK
I
Bit clock input pin. (Connected to GND)
56 ASDFIN — L/R channel data input pin. (Connected to GND)
57 LRSY — L/R clock output pin. (Not used)
58 DATACK O Bit clock output pin. (Not used)
59 DATA O L/R channel data output pin. (Not used)
60 16M O 16.9344MHz output pin. (Not used)
61 SFSY O
Subcode frame synchronization signal output pin. This signal falls when the subcode is in the
standby state. (Not used)
62 SBSY O Subcode clock synchronization signal output pin. (Not used)
63 PW O Subcode P, Q, R, S, T, U and W output pin. (Not used)
64 SBCK I Subcode readout clock input pin. (Connected to GND)
65 CE I Chip enable signal input pin.
66 CL I Data transfer clock input pin.
67 DI I Data input pin.
68 DO O Data output pin.
69 INT O Interruption signal output pin. (Not used)
70 WRQ O Interruption signal output pin.
71 RES I Reset input pin. This pin must be set low briefly after power is first applied.
72 DRF O Focus ON detect pin.
73 C2F — Microprocessor interface power supply.
74 VDD — Digital ground pin.
75 DOUT I/O General-purpose input/output pin 6. (Not used)
76 CONT7 I/O General-purpose input/output pin 7. (Not used)
77 V/P O
Rough servo/phase control automatic switching monitor output pin.
“ H” for rough servo and “ L” for phase servo. (Not used)
Summary of Contents for NSX-SZ6
