SETTING THE TIMER
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly. (See page 6.)
Use the remote control.
1 Press the TIMER button once to display
5
, and
press the
a
SET button within 4 seconds.
5
is displayed, and the hour flashes.
If you do not press the
a
SET button within 4 seconds, another
operation may start.
2 Designate the hour of the timer-on time by
pressing the
f
DOWN or UP
g
button, and
the
a
SET button. Repeat to designate the minute
of the timer-on time.
After you designate the timer-on time, one of the source name
flashes on the display.
3 Press one of the function buttons to select a
source, and press the
a
SET button.
If the TUNER button is pressed, the band cannot be selected
in this step.
4 Select the duration for the timer-activated period
with the
f
DOWN or UP
g
button, and press
the
a
SET button.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
5 Prepare the source.
To listen to a CD, load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
6 Press the POWER button to turn the unit off after
adjusting the volume and tone.
5
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
To check the specified time and source
Press the TIMER button. The timer-on time, the selected source
name and the duration for the timer-activated period are displayed
for 4 seconds.
TIMER RECORDING
Timer recording is applicable for TUNER, VIDEO 1/MD and
VIDEO 2/AUX (with an external timer) sources only.
Press the TIMER button twice on the remote control so that
%
appears on the display, and press the
a
SET button within
4 seconds. Repeat the steps shown above from step 2 and
insert the tape to be recorded into deck 2 after step 5.
To cancel timer standby mode temporarily
Press the TIMER button on the remote control so that
5
or
%
disappears on the display.
To restore the timer standby mode, press again to display
5
or
%
.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone.
• Timer playback and timer recording will not begin unless the
power is turned off.
• Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
TIMER
23
ENGLISH
Timer-activated period
source name
