7
ENGLISH
SPECIFICATIONS
RADIO SECTION
(FM)
Frequency Range:
87.5 MHz – 108 MHz
Usable Sensitivity:
12.7 dBf
50 dB Quieting Sensitivity:
17.2 dBf
IF Rejection:
100 dB
Frequency Response:
30 Hz – 15,000 Hz
S/N Ratio:
70 dB
Stereo Separation:
35 dB at 1 kHz
Alternate Channel Selectivity:
90 dB
Capture Ratio:
3 dB
(AM)
Frequency Range:
530 kHz – 1,710 kHz
Usable Sensitivity:
30 µV (30 dB)
CD SECTION
Frequency Response:
17 Hz – 20 kHz +0/–3 dB
Dynamic Range:
More than 85 dB
Channel Separation:
More than 60 dB
S/N Ratio:
More than 90 dB
Wow/Flutter:
Unmeasurable
AUDIO SECTION
Max. Power Output:
45 W
×
4 channels
AUX input
Input sensitivity (load impedance) AUX:
300 mV
(10 k
Ω
)
GENERAL
Power-Supply Voltage:
14.4 V (11 to 16 V
allowable), DC, negative ground
Load Impedance:
4
Ω
Tone Control:
Bass ± 10 dB at 100 Hz, Treble ± 10 dB at 10 kHz
Preamp Output Voltage (load impedance):
2.2 V
(10 k
Ω
)
Installed size:
182 (W)
×
53 (H)
×
155 (D) mm
(7
1
/
4
(W)
×
2
1
/
8
(H)
×
6
1
/
8
(D) inches)
Supplied Accessory:
Carrying case (1)
CARD REMOTE CONTROL
Dimensions:
approx. 33 (W)
×
85 (H)
×
7.5 (D) mm
(1
5
/
16
(W)
×
3
3
/
8
(H)
×
5
/
16
(D) inches)
Weight:
approx. 20g (0.7 oz.) (including battery)
• Specifications and external appearance are subject to
change without notice due to product improvement.
CAUTION
•
Lithium battery (CR2025) for the remote control
Replace the battery with Hitachi Maxell, Panasonic or
Sony Part No. CR2025 only. Use of another battery
may present a risk of fire or explosion.
The battery may explode if mistreated. Do not recharge,
disassemble or dispose of in fire.
• Keep the lithium battery out of the reach of children. If
swallowed, consult a doctor immediately.
• To prevent a short circuit, never pinch the battery with
pliers, etc.
TROUBLESHOOTING
Error code
In the following cases the corresponding error code
indication appears. Follow the suggestions below to
solve such problems.
E03
Focus error. Check that the CD is loaded properly
(right side up, etc.), and the CD contains valid
data.
Reset button
If a CD does not operate properly, press the reset button
with a pointed object such as a pencil, etc. Note that all
your settings will be erased if this button is pressed.
Reset button
MAINTENANCE
Cleaning the front panel
Wipe the surface with a soft, dry cloth. Do not use liquid
cleaners or aerosol cleaners.
Cleaning the connector
The connector needs to be cleaned occasionally. Wipe
the surface of the connector with a cotton swab slightly
moistened with alcohol.
Back of the front panel
