3
ENGLISH
3
ENGLISH
Setting the clock
1
Press and hold
DSPL
until the clock indicator
flashes in the display.
2
Press + (to set hour) or – (to set minute), and then
turn
Jog dial
.
3
Press
DSPL
.
Displaying the clock
1
Press
DSPL
.
To return to the former display,
press
DSPL
again.
RADIO OPERATION
Tuning in to a station
(Seek/Manual Tuning)
LO
TU (TUNER)
+/–
Local indicator
Stereo indicator
Band indicator
Frequency
TUNER
indication
indication
1
Press
TU (TUNER)
repeatedly to select the desired
band (FM1, FM2, FM3, AM1, or AM2).
2*
Press + (to move to higher frequencies) or – (to
move to lower frequencies) to tune in to a station.
“STEREO” appears on the display when an FM
station is broadcasting in stereo, and receiving
conditions are good.
*Seek Tuning and Manual Tuning
• Press and hold + or – until seek Tuning starts.
The unit locates a station automatically (Seek Tuning).
• Press + or – repeatedly to search for a desired station
while increasing or decreasing the frequency step by
step (Manual Tuning).
To stop Seek Tuning,
press + or – again.
Adjusting sound
You can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) and H-BASS (high bass).
1
Press
SEL
repeatedly to select the mode to be
adjusted.
Pressing
SEL
cycles through the modes. The
selected mode’s indicator appears.
2
Turn
Jog dial
to increase/decrease the level or to
select on/off for the selected mode.
Note
Adjust the level or select on/off within 5 seconds, or the
selected mode will return to previous state.
Aligning the source levels
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode’s
volume to almost the same level.
1
Press
Jog dial (PUSH-SOURCE)
or
TU (TUNER)
repeatedly to select the desired mode.
2
Press
DSPL
while pressing
SEL
.
“LA 0” appears on the display.
3
Turn
Jog dial
to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
Restoring the factory settings
1
Turn off the unit.
2
Press and hold
DSPL
until “LA --” appears on the
display.
Note
You can restore the factory settings only for VOL, BASS,
TRE, BAL, FAD, and H-BASS, and aligned source
volume levels.
Setting the beep tone
1
Turn off the unit.
2
Press and hold
SEL
until “bEEP” appears on the
display.
3
Turn
Jog dial
to select on (level indicators appear)
or off (level indicators disappear).
4
Press
SEL
.
