Shenzhen Aituo Automation Device Co.,Ltd
17
4
、
Q:How to adjust when stripping will harm to the copper wire or can’t strip the outer skin
completely?
A
：
The solutions as follow
：
1
Check whether the top and bottom knives of cutting parts are damaged or not,if yes,pls change
the new knife, and after fixed new knife ,pls make sure the position as the same.
2
If the knife is ok ,just only need to adjust the position of top and bottom knives to the proper
distance
（
as follow picture
）。
5
、
Q:How to adjust when the wire be pulled broken on the pulling workstation?
A:Screw the nuts,to adjust the proper distance between the up and down knives on the closure
status,and then tighten the nuts.
6
、
Q:How to adjust when soldering the inner rubber can not add the solder wire?
A:As follow solutions:
1
Check whether the solder wire on the feeding tin parts is enough.(as the picture1).
Adjust the nut
Top knife
Bottom knife
Knife edge
Adjust the distance to the proper
position to strip the wire
