8
Lay out the jump mat in the center of the frame with
the enclosure mesh facing up. Then slide a suspension
cord from left to right through the nylon loop you
picked in step 7, as shown. (When securing the
cords always position your left hand under, and right
hand over, the frame.)
9
Use your right hand to stretch the ‘loop’ end
of the cord OVER the top rail and your left
hand to pull the ‘knob’ end of the cord UNDER
the top rail, then pass the knob through the
loop.
11
10
15
TRAMPOLINE & ENCLOSURE ASSEMBLY
Refer to PARTS LIST for identification of parts.
SLOWLY release the loop end of the cord so
that it captures the knob, locking the
suspension cord in place, as shown.
Use care when releasing the loop end
around the knob, so that it does not slip off
or pinch your fingers!
From the 1st attached cord, count around the
jump mat to the 16th loop and repeat steps 1-3
attaching the 2nd cord directly across from the 1st.
1
2
12
Next, count back around the jump mat 8 loops
and repeat steps 1-3 attaching the 3rd cord
about half way between the 1st & 2nd cords.
13
!
WARNING:
CHOKING HAZARD - Small Parts
Not for children under 3 yrs.
!
WARNING:
ADULT ASSEMBLY REQUIRED
Contains small parts, sharp points and sharp edges.
1
2
3
4
5
6
7
8
Then, from the 3rd attached cord, count
around the jump mat 16 loops and repeat
steps 1-3 to attach the 4th cord. Numbers
on the picture above show the approximate
positions of the first 8 suspension cords.
Continue connecting the remaining cords
as shown in steps 1-3, but always connect
a cord, and then switch to the opposite
side of the trampoline to connect the
next cord. Attaching the cords in this
manner is important, as it will ensure
even-tension around the entire jump mat.
As you work, keep the enclosure mesh
gathered to the center of the mat.
14
Lay the pad cover, AirZone printed side up,
over the suspension cords. Carefully position
each of the 6 openings in the pad cover over their
corresponding enclosure pole sockets, as shown.
Enclosure pole
socket
Carefully work the lower mesh skirt (attached to the pad cover)
down, around the entire perimeter of the trampoline, on the outside of the legs.
16
Align the grommet attached to the bottom of the lower mesh skirt with the
hole near the base of the leg and secure with screw. DO NOT OVER-TIGHTEN.
17
Repeat Step 9 with the remaining 5 grommets in the
lower mesh skirt and their corresponding legs.
6
1
3
2
NEVER ALLOW A CHILD
TO USE OR JUMP ON THE
TRAMPOLINE WITHOUT
THE ENCLOSURE
PROPERLY ASSEMBLED
AND INSTALLED
!
WARNING:
2
