6
Adjusting Room Temperature
•
For a cooler temperature setting, turn the thermostat knob counterclockwise
until the desired thermostat setting is reached. (Note: The appliance will
remain off until the room has cooled below the thermostat setting and will
then resume operation until the room has sufficiently heated.)
•
For a warmer temperature setting, turn the thermostat knob clockwise until
the desired thermostat setting is reached. (Note: The appliance will run until
the room temperature has reached the thermostat setting and will then turn
off until the room has cooled.)
Turning the Appliance OFF
•
To turn heater off, deactivate the on/off switch
to the OFF (“O”) position.
The switch light will turn off when deactivated.
(Note: If the switch light is on, the appliance is NOT off, and may later
continue to run, even if it is not currently running. The appliance cannot be
completely turned off by use of the thermostat knob alone.)
Figure 9: Appliance Controls
Figure 10: Air Flow Blockage Warning
CLEANING AND MAINTENANCE
There are no serviceable parts inside the appliance. No
maintenance or repair should be attempted after installation with
exception to that which is described below.
The appliance is NOT to be opened or attempted to be opened by the
user.
•
Outside surfaces of the appliance may be cleaned as needed. Do not open
or disassemble the appliance for cleaning.
•
Clear all dust, dirt, and other substances from air openings on the front and
back of the appliance. Check the appliance annually for dust and dirt
accumulation.
•
Before cleaning, make sure the power has been turned off at the circuit
breaker panel and that the heating element of the appliance is cool.
•
Clean the appliance when cool with ordinary cleaning products. Avoid
abrasive or corrosive cleaning products.
•
NEVER
spray cleaning spray in any air slots or openings.
Storage
•
Hard-wired installation models (SEHNB, SEHNW) are
NOT
to be removed
from their mounting locations for consumer storage.
•
Corded installation models (SEHCB, SEHCW) may be stored when not in
use. Store in a dry location, protected from any physical damage to the
appliance. Keep mounting thumb screws in a safe, accessible location for
future use.
•
If stored, do not plug in or turn on this appliance until it has been properly
re-installed on its wall mounting bracket as shown per mounting instructions
on pages 3 and 4.
Troubleshooting
If the appliance does not heat, check the circuit breaker, the position of the
on/off switch, and the thermostat knob setting.
This appliance is equipped with safety high limit switches that shut the
appliance down if it overheats. After the cause has been addressed (for
example, removing blockages to the air inlet or outlet openings), place the
on/off switch in the OF
F (“O”) position and allow time for the
appliance to cool
before operating the appliance again.
If you cannot solve the problem, notify the contractor who installed the
appliance, or contact Suburban Customer Service (423-775-2131 EXT 7101).
To facilitate and speed up your inquiry, please provide the serial number from
the rating label on the side of the appliance.
This appliance may not be serviced or modified by the end user under
any circumstances.
