flange, making sure not to overtighten the
screws to avoid cracking the flange.
STEP 5
After the
MAXXFAN MINI Deluxe
hood has
been installed, remove the excess BUTYL
caulk that may have squeezed out. Using a
sealer such as Dicor self-leveling lap sealant
or similar caulking, apply a daub over every
exposed screw head. In addition, apply a
bead (approximately 3/16” dia.) along the
outside edge of the flange all the way
around the vent.
THIS COMPLETES THE ROOF TOP
PORTION OF THE INSTALLATION
CAUTION!
Disconnect main vehicle power
before connecting 12 volt DC power to the
MAXXFAN MINI Deluxe
!
STEP 6
Remove the 4 screws holding the plastic
cover in place and insert the 12 volt DC
power supply wires into the open hole in the
side of the molded box on the
MAXXFAN
MINI Deluxe
, allowing 4 to 6 inches of wire
inside the molded box. Using the supplied
wire nuts, connect the Positive (+) 12VDC
supply wire to the
MAXXFAN MINI Deluxe
mark
ed “POS 12VDC” and the Negative (-)
12VDC supply wire to the
MAXXFAN MINI
Deluxe
wire marked “Neg. 12VDC”.
Insert the RJ45 cable plug into the
connector on the PC Board.
Secure the wires in the box by reinstalling
the lid ensuring the wires are routed through
the built-in strain relief section of the box.
Rotary Switch Models:
Using the supplied
wire nuts, connect the Positive (+) 12VDC
supply wire to the
MAXXFAN MINI Deluxe
marked “POS 12VDC” and the Negative (-)
12VDC supply wire to the
MAXXFAN MINI
Deluxe
wire marked “Neg. 12VDC”.
STEP 7
Route supply wires and RJ45 cable to notch
in the back of the
MAXXFAN MINI Deluxe
interior plate, place sleeve over interior plate
with supply wires routed through hole
formed between interior plate and sleeve.
RJ45 cable can be routed through any side
of the
MAXXFAN MINI Deluxe
as needed.
Rotary Switch Models
: Route supply wires
through notch in the back of the MAXXFAN
MINI Deluxe interior plate. Place sleeve over
interior plate with supply wires routed
through hole formed between interior plate
and sleeve.
STEP 8
Raise the interior plate to the ceiling
ensuring that the flange on the interior plate
meshes with the
roof top flange. Press up on
the interior plate until it is tight to the ceiling.
Rotary Switch Models: This
complete the installation of the
MAXXFAN MINI Deluxe
STEP 9
Select a convenient location for the wall
control, keeping in mind the wall control with
the motion sensor will turn on the light when
it senses movement.
