■
The unit is better not be installed
at the below places, or it will cause
damage.
■
The place where there is corrosive
gas (spa area etc).
■
The place blowing salty air (seaside
etc).
■ Exists the strong coal smoke.
■
The place with high humidity.
■
The place where there is device
emitting Hertzian waves.
■
The place where voltage changes
greatly.
■ The place where the water can flow
fluently.
■
The place where no other heat
source will affect the unit.
■
Pay attention to the snow against
clogging the outdoor.
■
In installation, install the anti-
vibration rubber between the unit
and the bracket.
The unit should be installed at the
place where the cold/hot air or
noise will not interfere the neighbours.
(3) Transportation
■
Please remove the outdoor unit to the installation location as far as possible near place befor open the packaging.
■
Forbid on the equipments to place anything, need to use 2 ropes while promoting outdoor.
■
Please according to following way hoisting outdoor:
Ensure that the outdoor unit when hosting the level to rise slowly.
Do not remove the packaging.
When hoisting do not have to tie up the elevator to the unit hits on the packaging and the outside wrapping.
When hoisting exterior must use the suitable protection.
Handling
Before the installation,outdoor do not deposit any material,otherwise likely has the fire or the accident.
When handling unit,please operate as shown in the following figure and note the following points
1.Forbids to demolish the wooden foundation.
2.Prevent the outdoor to incline.
3.Should be handling more than two.
handle 1
handle 2
handle 3
handle 4
27
Summary of Contents for YEVFD Series
