10
Operation
•
To warm up the system, the power mains must be turned on at least five
(5) hours before operation.
•
The ST-NDHP76/96 does not have a dry function.
STEP 1
To start the air conditioner
Press the operation button (ON/OFF button).
STEP 2
Setting the mode
Press the MODE button to select the mode of your choice.
[
(AUTO),
(HEAT),
(DRY),
(COOL) or
(FAN)]
STEP 3
Setting the fan speed
Press the FAN SPEED selector button to select the fan
speed of your choice.
[
(AUTO),
(HI.),
(MED.) or
(LO.)]
If AUTO is selected, the fan speed switches automatically.
STEP 4
Setting the temperature
Use the
or
button as appropriate to change the
temperature setting as desired.
(
reduces the temperature, and
increases the
temperature.)
* The temperature cannot be set during FAN mode operation.
STEP 5
Setting the airflow direction
When more than one indoor unit is connected, the UNIT
button is used first to select a unit. Then use the FLAP button
to set the airflow direction to a specific angle or to sweep.
STEP 6
To stop the air conditioner
Press the operation button (ON/OFF button) again.
Automatic heating and cooling
The air conditioner automatically performs heating and cooling operation
based on the difference between the temperature setting and room
temperature. All indoor units in the same refrigerant system can be operated
with a single group control.
Simultaneous operation of
multiple units (Group control)
Group control is suitable for air conditioning of a large room using multiple air
conditioning units.
•
One remote control unit can control up to eight indoor units.
•
All indoor units have the same settings except for the airflow direction.
•
The temperature sensors at the indoor unit side are used.
NOTE
STEP 2
STEP 1, 6
STEP 3
STEP 4
STEP 5
Outdoor unit
Signal line
Remote control unit
Indoor unit
OI-824-10-EG
01_Airwell_ST-NKFL7R_EN.fm Page 10 Thursday, June 15, 2006 4:18 PM
Summary of Contents for ST-NDHP 24R
Page 36: ...WEEE USER MANUAL...
