8
Operation instruction
Press ON/OFF switch on wire controller
directly
The wire controller displays the running
state in the latest time (timing and swing
state may not be displayed).
1. Press "ON/OFF" switch.
The air conditioner starts operating, and the
light on the wired controller is on.
3.Press "TEMP" switch
Change set temperature:press TEMP
or
TEMP
every time, [SET] will display, and
set temperature will increase/reduce 1*
4.Press "FAN SPEED" switch
FAN ONLY Operation:
Press "FAN SPEED" switch to change to
"HIGH"--"MED"--"LOW"--"HIGH"
In AUTO,COOL,DRY,HEAT Operation:
Press "FAN SPEED" switch to change to
"AUTO"--"HIGH"--"MED"--"LOW"--"AUTO"
5.Press "SWING" switch on the wire
controller to swing the wind screen.
6.Press "ON/OFF"switch, off.
The light on the wire controller is off.
2.Choose operation mode.
Press "mode"switch to change to
"AUTO"---"FAN ONLY"---"COOL"---"DRY"---
"HEAT".
Remarks
Avoid pressing "ON/OFF" switch frequently.
Do not press wire controller or switches by sharp objects.
The temperature is on the basis of the setting value. The wind temperature may not reach the
setting value because of the outer air conditioner and system protection.
When the wired controller is power on, the screen fully displays it for two seconds. and clock
zone "8888"-"888"-"88"-"8" flicker for 30 seconds. All the switches are invalid at the time.
Note
Several seconds after the operation of the wire controller, the setting of the unit will change.
ON/OFF operation
HIGH
ROOM TEMP.
COOL
FAN
OPERATION
MODE
CLOCK
MODE
FAN
SWING
HEALTH
CLOCK
TIMER
CHECK
FILTER
RESET
ON/OFF
SET
RECOVERY
TEMP
TIME
2
4
5
3
1
6
Summary of Contents for AWSI-DBV018-N11
Page 37: ......
