4
Air-conditioner can't be
installed in the place with
inflammable gas. Or it
will cause fire hazard.
The unit should be installed at the
strong enough place. Or it will cause
vibration and noise.
The unit should be
installed at the place
where the cold/hot air or
noise will not interfere
the neighbours.
The unit is better not be installed
at the below places, or it will
cause damage.
The place where there is
corrosive gas (spa area etc).
The place blowing salty air
(seaside etc).
Exsits the strong coal smoke.
The place with high humidity.
The place where there is device
emitting Hertzian waves.
The place where voltage changes
greatly.
In transportation, please don't dismantle the packaging, and move the unit to the installation
location as closely as possible.
If the packaging must be dismantled, hang up the unit with rope against damage.
Don't hang the unit only at two points. When hanging the unit, don't sit on the unit. The unit
should be upright.
When removing the unit with the forklift, put the fork into the special hole at bottom of the unit.
When being hanged, the rope should be 4 pieces of steel cable with over 6mm diameter.
Put the cushion at the contact section between steel cable and the unit against the distortion
or damage.
(3) Transportation
The place where the water
can flow fluently.
The place where no other
heat source will affect the
unit.
Pay attention to the snow
against clogging the outdoor.
In installation, install the anti-
vibration rubber between the
unit and the bracket.
Installation instruction
Note:
1.The place where outdoor unit located must be keep out of water.
2. In snowy area, install the unit under the bracket or the snow-proof cover against the
accumulative snow on the unit.
3. Do not install the unit at the place where the flammable gas will leak.
4. Install the unit at the strong enough place.
5. Install the unit at the flat place.
6. When being installed at the place with strong wind, set the air outlet of the unit and the wind
direction vertical. Also fix the unit with the screw.
(2) Installation place selection
The unit should be installed
at the place with good
ventilation. No obstacle at the
air inlet/outlet. And no strong
wind blows the unit.
The installation space refers
to the latter info.
