General Maintenance
Tire Pressure:
Max pressure is 115 PSI. Lower pressure will provide improved traction when
necessary.
Battery:
Keep the battery fully charged. Battery maintainers are available by calling Airtug at
216-941-9781.
Hydrostatic Transaxle:
This should be checked for oil level. Add 20W-50 oil if level is low.
Drive Wheel Bearings:
Permanently lubricated.
Caster Zerk Fittings:
Needs to be lubed periodically to ensure ease of caster wheel steering.
Drive Chains:
Apply chain lube periodically depending on use and environment.
Tractive Ability:
If the tug seems to be losing tractive ability, it’s an indication of a loose drive belt.
The engine plate is mounted on slotted holes and can be moved rearward, toward the operator, to
tighten the drive belt if necessary. Simply loosen the nuts, push the engine plate towards the rear of
the tug and tighten the nuts firmly.
Engine:
Oil should be changed at regular intervals depending on use. Refer to engine owners manual. Note: there is
a drain hose on the side of the engine for this purpose.
CAUTION:
* Read, study and understand all warnings and operating instructions prior to use
* When working on the tug:
* Put the tug up on blocks to get the drive wheels off the ground before beginning any work.
* Do not allow anyone to stand directly in front of or behind the vehicle during testing.
* Make sure the Power switch is off.
* Use well-insulated tools.
* RUNAWAYS - Some conditions could cause the tug to run out of control. Jack up the tug and get the drive
wheels off the ground before attempting any work on the engine control circuitry.
* HIGH CURRENT ARCS - Batteries can supply very high power and arcs can occur if they are short circuit.
Wear safety glasses, and use properly insulated tools to prevent short circuit.
* Do not overload this tug beyond the rated capacity.
* This tug is designed for use only on hard level surfaces capable of sustaining the load.
* No alterations to the tug shall be made.
*
Electronic components may be damaged if exposed to water!
This is not covered under warranty.
*
Failure to heed these warnings may result in personal injury and/or property damage.
Assembly Instructions
Note:
Carefully remove shrink wrap and banding.
Tools Needed For Assembly:
Wire cutter, utility knife, 5/16” & 3/8” sockets.
Assembly Note:
All reference to “right” and “left” orientation is made while standing behind the tug
and looking forward from the operating position.